Loading... Please wait...
  • Gift Certificates
  • My Account 

Currency Displayed in

Erector Meccano Spykee Robot Battery Replacement Instructions

Posted by


Battery Replacement Instructions for Erector Meccano 870850E Spykee Wi-Fi Spy Robot

 

Instructions provided by mpfproducts.comspykee-robot.jpg

Necessary Parts: Replacement 8LMH-48AA1800-H-MA Battery for Spykee Spy Robot


This repair should take approximately 30 minutes.

1. Remove the treads from the bottom of the robot.

2. On the bottom of the robot are eight screws. Remove the screws and then split the case open. It will just come apart if all 8 screws are removed. Be careful of the wires connecting the top of the robot to the base.

3. With caution, it will not be necessary to disconnect the four connectors but be sure to not put any strain on them. I always disconnect them. Just be sure to note where they go.

4. There are four screws holding this board in place. One of the screws is under tape located on the upper right hand corner with the robot facing you. There are multiple cables connected to the circuit board. Do not disconnect any of these. They can carefully be moved out of the way for the next step if you need.

5. Once the circuit board is removed, there is a plastic cover held on by four more screws. Unscrew the four screws and remove the cover. Under this cover, you will find the battery pack.

6. The pack is connected to the robot with a connector with a clip. To remove, press down on the clip and separate at the connector.

7. Take your new battery pack and plug it in where the old one was. It will only go in one way.

8. Reverse repair instructions to reassemble the Spykee robot.




 

What's News

Copyright 2024 MPF.All Rights Reserved. MPF Products® is a Registered Trademark.
 Sitemap |